O&M

The Kansas City Power & Light (KCP&L) La Cygne Generating Station provides 1,532 MW of peak power from its site south of Kansas City. La Cygne Unit 1 is an 815-MW Babcock & Wilcox cyclone boiler

  Lubricating oil is the lifeblood of virtually all rotating equipment found in a power plant. Keep it clean and the lube system is relatively low maintenance. However, cycling operation and restarts after a temporary or long-term shutdown can reveal a whole new class of perhaps unfamiliar problems. The fundamental question is determining when a […]

Aging human machine interface (HMI) hardware will eventually become a burden on plant operation. Obsolete HMIs can cause problems with connectivity, historical data loss, and hardware failure. As the hardware

Like any internal combustion engine, the power output and efficiency of a combustion turbine decrease as ambient temperatures rise. This loss of power and efficiency is caused by a reduction in ambient air density at higher temperatures. Since turbines are mass flow machines with a volumetrically limited intake, less-dense intake air results in degradation of […]

Meaningful, yet often hidden thermal performance losses occur in feedwater heaters.

American Electric Power (AEP) has opted to retire—instead of refueling with natural gas—its 585-MW coal-fired Muskingum River Plant Unit 5 in Beverly, Ohio, in 2015.

At the average coal-fired power plant, the battle to reduce net heat rate is complicated by skin-tight maintenance budgets, staff reductions, and—for some—the switch from baseload to mid-peaking service. The most fruitful approach to improving a plant’s heat rate is to optimize combustion in its boiler, particularly by minimizing the amount of “stealth” air in-leakage.

Understand how to best use a new tool-in this case, the measurement of oxidation-reduction potential—and avoid another on-line gadget.

Cycling is a fact of life for most gas plants. But do you really understand the true costs of cycling operation? Not having a full picture risks leaving substantial money on the table.

There are many reasons to anticipate that the use of wireless instrumentation in industrial settings will increase dramatically in the next few years.